Setup Guide

Dell Networking OS

To initially configure the Dell Networking operating system (OS), use the

following sections.

NOTE: This topic applies ONLY if you already have the Dell Networking

OS installed on your system from the factory. If you are installing a third-

party OS, see your third-party OS documentation.

NOTE: For complete installation and configuration information, see the

following documents at www.dell.com/support:

• Dell Networking Installation Guide for the S6100–Open Networking

(ON) System.

• Dell Networking Command Line Reference Guide for the S6100–

Open Networking (ON) System.

• Dell Networking Configuration Guide for the S6100–Open

Networking (ON) System.

• Dell Networking Release Notes for the S6100–Open Networking

(ON) System.

Enter the Initial Configuration Information

To set up the switch, assign an IP address and other configuration information

necessary for the switch to communicate with the local routers and the

Internet. The minimal configuration provided here does not cover most of the

features; it simply allows you to perform other configuration tasks using a

Telnet connection from your management network.

NOTE: To configure other features and interfaces, see the Dell

Networking OS Configuration Guide for the S6100–ON System.

Dell Networking OS