Setup Guide

IP Settings

To set up the switch, get the following information from your network

administrator:

• Switch IP address

• Subnet mask (IP netmask)

• Default gateway (router)

• Enable secret password

• Enable password

• Telnet password

Navigating CLI Modes

The Dell Networking OS prompt changes to indicate the CLI mode.

You must move linearly through the command modes, except for the end

command which takes you directly to EXEC Privilege mode and the exit

command which moves you up one command mode level.

Accessing the Console

The RS-232 console ports are on the left-hand side of the S6100–ON system

as you face the PSU side of the chassis, as shown in the following illustration.

Figure 10. S6100–ON RS-232 Console Ports

1. Top: RJ-45 console port.

Bottom: RJ-45 management

port

CAUTION: Ensure that any equipment attached to the serial port can

support the required 115200 baud rate.

Dell Networking OS