Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6100-ON
131132133134135136137138139140
• Disable BFD on an interface.
INTERFACE mode
no bfd enable
• Enable BFD on an interface.
INTERFACE mode
bfd enable
If you disable BFD on a local interface, this message displays:
If the remote system state changes due to the local state administration being down, this message displays:
Congure BFD for Static Routes
BFD oers systems a link state detection mechanism for static routes. With BFD, systems are notied to remove static routes from the
routing table as soon as the link state change occurs, rather than waiting until packets fail to reach their next hop.
Conguring BFD for static routes is a three-step process:
1 Enable BFD globally.
2 Congure static routes on both routers on the system (either local or remote).
3 Congure an IP route to connect BFD on the static routes using the ip route bfd command.
Related Conguration Tasks
• Changing Static Route Session Parameters
• Disabling BFD for Static Routes
Establishing Sessions for Static Routes
Sessions are established for all neighbors that are the next hop of a static route.
Figure 15. Establishing Sessions for Static Routes
To establish a BFD session, use the following command.
• Establish BFD sessions for all neighbors that are the next hop of a static route.
CONFIGURATION mode
ip route bfd
Bidirectional Forwarding Detection (BFD)
137