Users Guide
Dell#
Example of Viewing CAM-ACL Settings
NOTE: If you change the cam-acl setting from CONFIGURATION mode, the output of this command does not reect any
changes until you save the running-conguration and reload the chassis.
Dell#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 2
L2PT : 0
IpMacAcl : 1
VmanQos : 0
EtsAcl : 0
FcoeAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
-- stack-unit 1 --
Current Settings(in block sizes)
1 block = 256 entries
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 2
L2PT : 0
IpMacAcl : 1
VmanQos : 0
EtsAcl : 0
FcoeAcl : 0
ipv4pbr : 0
vrfv4Acl : 0
Openflow : 0
fedgovacl : 0
nlbclusteracl: 0
View CAM Usage
View the amount of CAM space available, used, and remaining in each ACL partition using the show cam-usage command from EXEC
Privilege mode.
Example of the show cam-usage Command
Dell#show cam-usage
Stackunit|Portpipe|Pipeline| CAM Partition | Total CAM | Used CAM |Available CAM
========|========|========|=================|=============|=============|==============
1 | 0 | 0 | IN-L2 ACL | 256 | 0 | 256
| | | IN-L3 ACL | 256 | 1 | 255
| | | IN-V6 ACL | 0 | 0 | 0
| | | IN-NLB ACL | 0 | 0 | 0
| | | IPMAC ACL | 256 | 0 | 256
| | | OUT-L2 ACL | 206 | 12 | 194
| | | OUT-L3 ACL | 172 | 8 | 164
| | | OUT-V6 ACL | 172 | 3 | 169
| | | IN-L3 FIB | 90112 | 28 | 90084
1 | 0 | 1 | IN-L2 ACL | 256 | 0 | 256
| | | IN-L3 ACL | 256 | 1 | 255
| | | IN-V6 ACL | 0 | 0 | 0
| | | IN-NLB ACL | 0 | 0 | 0
| | | IPMAC ACL | 256 | 0 | 256
| | | OUT-L2 ACL | 206 | 12 | 194
| | | OUT-L3 ACL | 172 | 8 | 164
| | | OUT-V6 ACL | 172 | 3 | 169
214
Content Addressable Memory (CAM)