Users Guide

Load-Balancing Method
By default, LAG hashing uses the source IP, destination IP, source transmission control protocol (TCP)/user datagram protocol (UDP) port,
and destination TCP/UDP port for hash computation. For packets without a Layer 3 header, Dell Networking OS automatically uses load-
balance mac source-dest-mac.
Do not congure IP hashing or MAC hashing at the same time. If you congure an IP and MAC hashing scheme at the same time, the MAC
hashing scheme takes precedence over the IP hashing scheme.
To change the IP trac load-balancing default, use the following command.
• Replace the default IP 4-tuple method of balancing trac over a port channel.
CONFIGURATION mode
[no] load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac | source-dest-mac |
source-mac]} | {tcp-udp enable} {ipv6-selection} {tunnel}| {ingress-port}
You can select one, two, or all three of the following basic hash methods:
• ip-selection [dest-ip | source-ip] — Distribute IP trac based on the IP destination or source address.
• mac [dest-mac | source-dest-mac | source-mac] — Distribute IPV4 trac based on the destination or source MAC
address, or both, along with the VLAN, Ethertype, source module ID and source port ID.
• tcp-udp enable — Distribute trac based on the TCP/UDP source and destination ports.
• ingress-port — Option to Source Port Id for ECMP/ LAG hashing.
• ipv6-selection— Set the IPV6 key elds to use in hash computation.
• tunnel— Set the tunnel key elds to use in hash computation.
Changing the Hash Algorithm
The load-balance command selects the hash criteria applied to port channels.
If you do not obtain even distribution with the load-balance command, you can use the hash-algorithm command to select the
hash scheme for LAG, ECMP and NH-ECMP. You can rotate or shift the 12–bit Lag Hash until the desired hash is achieved.
The nh-ecmp option allows you to change the hash value for recursive ECMP routes independently of non-recursive ECMP routes. This
option provides for better trac distribution over available equal cost links that involve a recursive next hop lookup.
To change to another algorithm, use the second command.
• Change the default (0) to another algorithm and apply it to ECMP, LAG hashing, or a particular line card.
CONFIGURATION mode
For more information about algorithm choices, refer to the command details in the IP Routing chapter of the Dell Networking OS
Command Reference Guide.
• Change the Hash algorithm seed value to get better hash value
Hash seed is used to compute the hash value. By default hash seed is chassis MAC 32 bits. we can also change the hash seed by the
following command.
CONFIGURATION mode
hash-algorithm seed {seed value}
• Change to another algorithm.
CONFIGURATION mode
360
Interfaces