Users Guide
VRF: 2 vrf2
State: Master, Priority: 100, Master: 10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 419, Gratuitous ARP sent: 1
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.100
Authentication: (none)
VRRP for IPv6 Conguration
This section shows VRRP IPv6 topology with CLI congurations.
Consider an example VRRP for IPv6 conguration in which the IPv6 VRRP group consists of two routers.
Figure 149. VRRP for IPv6 Topology
NOTE
: This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP
conguration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your
own IP addresses, interfaces, names, and so on.
928 Virtual Router Redundancy Protocol (VRRP)