White Papers

CLI Command Mode Prompt Access Command
VRRP
DellEMC(conf-if-interface-type-
slot/port-vrid-vrrp-group-id)#
vrrp-group
UPLINK STATE GROUP
DellEMC(conf-uplink-state-
group-groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.
Example of Changing Command Modes
DellEMC(conf)#protocol spanning-tree 0
DellEMC(config-span)#
The do Command
You can enter an EXEC mode command from any CONFIGURATION mode (CONFIGURATION, INTERFACE, SPANNING TREE, and so
on.) without having to return to EXEC mode by preceding the EXEC mode command with the do command.
The following example shows the output of the do command.
DellEMC(conf)#do show system brief
Stack MAC : 4c:76:25:f5:06:80
Reload-Type : normal-reload [Next boot : normal-reload]
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
-----------------------------------------------------------------------
1 Management online S6100-ON S6100-ON 1-0(0-4703) 130
2 Member not present
3 Member not present
4 Member not present
5 Member not present
6 Member not present
-- Module Info --
Unit Module No Status Module Type Ports
---------------------------------------------------------
1 1 online S6100-MOD-16xETH40-F 16
1 2 online S6100-MOD-16xETH40-F 16
1 3 online S6100-MOD-16xETH40-F 16
1 4 online S6100-MOD-16xETH40-F 16
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
---------------------------------------------------
1 1 up AC up 12176
1 2 up AC up 12112
-- Fan Status --
Unit Bay TrayStatus Fan1 Speed
-------------------------------------
1 1 up up 7620
1 2 up up 7680
1 3 up up 7591
1 4 up up 7620
Speed in RPM
42
Conguration Fundamentals