Deployment Guide

38 Dell EMC Networking Virtualization Overlay with BGP EVPN
8.1.3 show lldp neighbors
The show lldp neighbors command is useful for identifying connected switches by port. The items listed
as Not Advertised are the server network adapters.
Leaf1a# show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
-----------------------------------------------------------------------------
ethernet1/1/31 Not Advertised f4:e9:d4:62:4b:c8 f4:e9:d4:62:4b:c8
ethernet1/1/32 Not Advertised f4:e9:d4:62:4b:80 f4:e9:d4:62:4b:80
ethernet1/1/53 Spine1 ethernet1/1/1 20:04:0f:05:c0:97
ethernet1/1/54 Spine2 ethernet1/1/1 50:9a:4c:d5:50:70
ethernet1/1/55 Leaf1b ethernet1/1/55 3c:2c:30:10:41:00
ethernet1/1/56 Leaf1b ethernet1/1/56 3c:2c:30:10:41:00
8.1.4 show uplink-state-group id_# detail
The show uplink-state-group id_# detail command shows the status of ports in the UFD group.
The status should be Enabled,up. Since UFD is configured in reverse, the VLT port channels connected to
the servers, Po 100 and Po 101, are shown as upstream interfaces and the ports connected to the spines
are shown as downstream interfaces. All interfaces are up.
Leaf1a# show uplink-state-group 1 detail
(Up): Interface up (Dwn): Interface down (Dis): Interface disabled (NA):
Not Available
*: VLT Port-channel V: VLT Status P: Peer Operational Status ^: Tracking
Status
Uplink State Group : 1 Status : Enabled,up
Upstream Interfaces : *Po 100(V:Up,^P:Up) *Po 101(V:Up,^P:Up)
Downstream Interfaces: Eth 1/1/53(Up) Eth 1/1/54(Up)