Install Guide
Table Of Contents
- Dell EMC PowerSwitch Z9264F-ON Installation Guide August 2021
- Contents
- About this guide
- Z9264F-ON switch
- Site preparations
- NEBS compliance
- Z9264F-ON switch installation
- Power supplies
- Fans
- Management ports
- Before you install an OS
- Specifications
- Chassis physical design
- IEEE standards
- Agency compliance
- USA Federal Communications Commission FCC statement
- European Union EMC directive conformance statement
- Japan VCCI compliance for class A equipment
- Korean certification of compliance
- China warning
- Safety standards and compliance agency certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell EMC support
Figure 9. Ground lug assembly
3. Measure and cut a length of ground wire sufficient to reach between the system-installed ground lug assembly and your rack
ground point.
4. Crimp the ground cable to the ground lug assembly.
a. Coat the bare end of the wire with an antioxidant compound.
b. Insert the end of the wire into the ground lug.
c. Crimp the ground lug end.
5. Clean the bracket and lug surfaces thoroughly, and apply an antioxidant solution to the mating surfaces.
6. Attach the switch ground lug assembly to the switch.
Figure 10. Ground lug assembly attached
7. Attach the GND lug bracket assembly to your switch using the two removed screws, as shown.
Torque the M4 screws to ±8–10 in-lbs.
Z9264F-ON switch installation
19