Users Guide
The show ip pim neighbor command displays the PIM neighbor of FHR and the interface to reach the neighbor.
FHR# show ip pim neighbor
Neighbor Address         Interface            Uptime/Expires         Ver        DR 
Priority/Mode
-----------------------------------------------------------------------------------------
----
2.2.2.1                  ethernet1/1/17      00:04:31/00:01:43        v2           1   / 
S
3.3.3.1                  ethernet1/1/31      00:05:45/00:01:31        v2           1   / 
S
FHR#
The show ip pim rp mapping command displays the multicast groups to RP mapping and information about how RP is
learned.
FHR# show ip pim rp mapping
Group(s) : 224.0.0.0/4,  Static
RP : 192.168.1.25, v2
Sample configuration in RP node:
RP# configure terminal
RP(config)# ip multicast-routing
RP(config)# interface ethernet 1/1/31
RP(conf-if-eth1/1/31)# no switchport
RP(conf-if-eth1/1/31)# ip address 3.3.3.1/24
RP(conf-if-eth1/1/31)# ip pim sparse-mode
RP(conf-if-eth1/1/31)# ip ospf 1 area 0
RP(conf-if-eth1/1/31)# exit
RP(config)#
RP(config)# interface ethernet 1/1/43
RP(conf-if-eth1/1/43)# no switchport
RP(conf-if-eth1/1/43)# ip address 1.1.1.2/24
RP(conf-if-eth1/1/43)# ip pim sparse-mode
RP(conf-if-eth1/1/43)# ip ospf 1 area 0
RP(conf-if-eth1/1/43)# exit
RP(config)#
RP(config)# interface loopback 0
RP(conf-if-lo-0)# ip address 192.168.1.25/32
RP(conf-if-lo-0)# ip ospf 1 area 0
RP(conf-if-lo-0)# exit
RP(config)# ip pim rp-address 192.168.1.25 group-address 224.0.0.0/4
RP(config)# end
RP#
RP# configure terminal
RP(config)# router ospf 1
RP(config-router-ospf-1)# end
The show ip pim interface command displays the PIM-enabled interfaces in RP.
RP# show ip pim interface
Address      Interface            Ver/Mode       Nbr Count    Query Intvl      DR Prio      DR
---------------------------------------------------------------------------------------------------
3.3.3.1      ethernet1/1/31       v2/S           1            30               1            3.3.3.2
1.1.1.2      ethernet1/1/43       v2/S           1            30               1            1.1.1.2
RP#
The show ip pim neighbor command displays the PIM neighbor of RP and the interface to reach the neighbor.
RP# show ip pim neighbor
Neighbor Address         Interface            Uptime/Expires         Ver        DR 
Priority/Mode
-----------------------------------------------------------------------------------------
------
3.3.3.2                  ethernet1/1/31      00:02:57/00:01:17        v2           1   / 
DR S
1.1.1.1                  ethernet1/1/43      00:06:35/00:01:39        v2           1   / 
S
RP#
1054
Multicast










