Users Guide

Usage
information
This command assigns the sensors from which data is collected for streaming telemetry to a subscription
profile and specifies the sampling rate. To add sensor groups to the subscription profile, reenter the
command. The interface sensor group supports only physical and port channel interfaces. The no
version of this command deletes the sensor group from the subscription profile.
NOTE: The subscription profile should contain either OS10 sensor groups or openconfig sensor
groups. Both sensor groups cannot co-exist in a single subscription profile.
Example
OS10(conf-telemetry)# subscription-profile sp01
OS10(conf-telemetry-sp-sp01)#
OS10(conf-telemetry-sp-sp01)# sensor-group
bgp BGP statistics sensor
group
bgp-peer BGP Peer statistics sensor group
buffer QOS Buffer statistics sensor group
device Device statistics sensor group
environment Switch peripheral statistics sensor group
interface Interface statistics sensor group
lag Lag statistics sensor group
system System statistics sensor group
oc-bfd Openconfig BFD statistics sensor group
oc-bgp Openconfig BGP statistics sensor group
oc-buffer Openconfig QOS Interface statistics sensor group
oc-device Openconfig Device statistics sensor group
oc-environment Openconfig Switch peripheral statistics sensor group
oc-interface Openconfig Interface statistics sensor group
oc-lacp Openconfig LACP statistics sensor group
oc-lag Openconfig LAG statistics sensor group
oc-lldp Openconfig LLDP statistics sensor group
oc-stp Openconfig STP statistics sensor group
oc-system Openconfig System statistics sensor group
oc-vendor-ufd Vendor UFD statistics sensor group
oc-vendor-vxlan Vendor VxLAN statistics sensor group
oc-vlan Openconfig VLAN statistics sensor group
oc-vrrp Openconfig VRRP statistics sensor group
OS10(conf-telemetry)# subscription-profile subscription-1
OS10(conf-telemetry-sp-subscription-1)# sensor-group bgp 30000
OS10(conf-telemetry-sp-subscription-1)# sensor-group environment 415000
Supported
releases
10.4.3.0 or later
encoding
Configures the encoding format used to stream telemetry data to a destination device.
Syntax
encoding format
Parameters format — Enter the gpb (Google protocol buffer) encoding format in which data is streamed.
Default None
Command mode SUBSCRIPTION-PROFILE
Usage
information
The no version of the command removes the configured encoding format from a subscription profile.
Example
OS10(conf-telemetry)# subscription-profile subscription-1
OS10(conf-telemetry-sp-subscription-1)# encoding gpb
Supported
releases
10.4.3.0 or later
Telemetry 1737