Users Guide

4. Use the show image status command to view the installation status.
VLT-Peer1# show image status
Image Upgrade State: idle
==================================================
File Transfer State: idle
--------------------------------------------------
State Detail: Completed: No error
Task Start: 2018-08-16T19:38:37Z
Task End: 2018-08-16T19:38:44Z
Transfer Progress: 100 %
Transfer Bytes: 417828173 bytes
File Size: 417828173 bytes
Transfer Rate: 58152 kbps
Installation State: idle
--------------------------------------------------
State Detail: Completed: Success
Task Start: 2018-08-16T19:40:57Z
Task End: 2018-08-16T19:45:16Z
VLT-Peer2# show image status
Image Upgrade State: idle
==================================================
File Transfer State: idle
--------------------------------------------------
State Detail: Completed: No error
Task Start: 2018-08-16T19:41:49Z
Task End: 2018-08-16T19:42:09Z
Transfer Progress: 100 %
Transfer Bytes: 417828173 bytes
File Size: 417828173 bytes
Transfer Rate: 21092 kbps
Installation State: idle
--------------------------------------------------
State Detail: Completed: Success
Task Start: 2018-08-16T19:42:59Z
Task End: 2018-08-16T19:47:19Z
5. Change the boot partition to standby on VLT-Peer1.
VLT-Peer1# boot system standby
6. Save the configuration to startup-configuration. Optionally obtain a backup of the startup configuration in EXEC mode on
VLT-Peer1.
VLT-Peer1# write memory
VLT-Peer1# copy config://startup.xml config://<backup file name>
7. Reload VLT-Peer1.
VLT-Peer1# reload
8. Wait for VLT-Peer1 to come up. VLT adjacency will be established. VLT-Peer1 becomes the secondary node. Wait until VLT-
Peer1 starts to forward traffic after the delay-restore timer expires.
9. Change the boot partition to standby on VLT-Peer2.
VLT-Peer1# boot system standby
10. Save the configuration to startup-configuration. Optionally obtain a backup of the startup configuration in EXEC mode on
VLT-Peer2.
VLT-Peer2# write memory
VLT-Peer2# copy config://startup.xml config://<backup file name>
11. Reload VLT-Peer2.
VLT-Peer2# reload
Getting Started with Dell EMC SmartFabric OS10
43