Owners Manual

USB-based firmware update
Update your BMC, BIOS, and CPLD firmware with the following commands:
Power on the switch
Plug in the power cable to the back of the switch. The switch powers up immediately.
Create a serial console connection
To establish a console connection, use a universal serial bus (USB)-to-RS-232 connection from a USB port to the switch
console port.
NOTE: The baud rate is 115200.
BIOS access process
1. Press delete after the POST Lower DRAM Memory test appears on the screen. Continue pressing delete to progress
to the BIOS setup and configuration screen.
NOTE:
If the BIOS setup and configuration screen window passes, power off and power on the platform again
to restart the boot up process.
Figure 2. Initial boot up screen
42
Firmware update