Deployment Guide

Parameters
address mac-
address
Display only information about the specified MAC address.
interface
ethernet
node/slot/
port[:subport
]
Display only MAC addresses learned on the specified interface.
interface
port-channel
number
Display only MAC addresses learned on the specified port channel.
static
Display only static MAC addresses.
dynamic
Display only dynamic MAC addresses.
Default Not configured
Command mode EXEC
Usage
information
By default, MAC learning from a remote VTEP is enabled. Use this command to verify the MAC addresses
learned both on VXLAN virtual networks and VLANs on the switch. The show mac address-table
command displays the MAC addresses learned only on LAN port and VLAN interfaces.
Example
OS10# show mac address-table extended
Virtual-Network VlanId MAC Address Type Interface/Remote-VTEP
----------------------------------------------------------------------------
- 500 00:00:00:00:11:11 dynamic ethernet1/1/31:1
- 500 00:00:00:00:44:44 dynamic port-channel1000
- 1 aa:bb:cc:dd:f0:03 static port-channel1000
- 500 aa:bb:cc:dd:f0:03 static port-channel1000
- 4000 aa:bb:cc:dd:f0:03 static port-channel1000
10000 00:00:00:00:00:11 dynamic ethernet1/1/31:1
10000 100 00:00:00:00:00:44 dynamic port-channel1000
10000 100 00:00:00:00:00:55 dynamic port-channel10
10000 00:00:00:00:00:77 dynamic VxLAN(32.1.1.1)
20000 300 00:00:00:00:00:22 dynamic port-channel100
20000 300 00:00:00:00:00:33 dynamic port-channel1000
20000 300 00:00:00:00:00:66 dynamic port-channel10
20000 00:00:00:00:00:88 dynamic VxLAN(32.1.1.1)
Supported
releases
10.4.2.0 or later
show mac address-table nve
Displays MAC addresses learned on a VXLAN virtual network or from a remote VXLAN tunnel endpoint.
Syntax
show mac address-table nve {vxlan-vni vni | remote-vtep ip-address}
Parameters
vxlan-vni vni
Display MAC addresses learned on the specified VXLAN virtual network, from 1 to
16,777,215.
remote-vtep
ip-address
Display MAC addresses learned from the specified remote VTEP.
Default Not configured
Command mode EXEC
Usage
information
Use the clear mac address-table dynamic nve remote-vtep command to delete all MAC
address entries learned from a remote VTEP. Use the clear mac address-table dynamic
virtual-network vn-id command to delete all dynamic MAC address entries learned on a virtual-
network bridge.
34 VXLAN