Install Guide

LED Description

• Solid yellow—Link operating at a lowr speed, 4x10G port

• Flashing yellow, 1 second on/off—Port beacon

Link/Activity LED—2x50G mode

• Off—No link

• Solid yellow—Link operating at a lower speed, 2x50G port

• Flashing yellow—Port activity at a lower speed, 2x50G port

• Flashing yellow, 1 second on/off—Port beacon

Prerequisites

The following is a list of components that are required and optional for successful switch installation:

NOTE:

For detailed installation instructions, see Site preparations and Z9264F-ON switch installation.

• Z9264F-ON switch or multiple switches, if stacking

• AC or DC country- and regional-specific cables to connect the AC or DC power source to each of the AC or DC power supplies

• Rail mounting brackets for rack installation, included

• M4 screws for rack installation

• #1 and #2 Phillips screwdrivers, not included

• Torx screwdriver, not included

• Ground cable screws for L-bracket, included

• Copper/fiber cables

Other optional components are:

• M4 ground cable screw

• Extra power supply unit

• Extra fan module

NOTE:

The DC ground lug kit ships with the other accessories inside the shipping box.

Z9264F-ON switch configurations

You can order the Z9264F-ON switch in several different configurations.

• Z9264F-ON AC or DC Normal Airflow—sixty-four 1/10/25/40/50/100 GbE ports, two SFP+ 1/10 ports, two AC or DC power supply

and four fan subsystems with airflow from the I/O side to the power supply side

• Z9264F-ON AC or DC Reverse Airflow—sixty-four 1/10/25/40/50/100 GbE ports, two SFP+ 1/10 ports, two AC or DC power supply

and four fan subsystems with airflow from the power supply side to the I/O side

• Fan with airflow from the I/O side to the PSU side—normal airflow

• Fan with airflow from the PSU side to the I/O side—reverse airflow

• AC or DC power supply with airflow from the I/O side to the PSU side—normal airflow

• AC or DC power supply with airflow from the PSU side to the I/O side—reverse airflow

Luggage tag

The switch has a pull-out tag, known as a luggage tag, on the I/O-side of the switch. The front of the luggage tag includes switch ID

information. The back of the luggage tag includes a QRL that takes you to a How-To site where you can watch videos about racking the

switch, replacing components, configuring port channels, and so on.

Z9264F-ON switch