Install Guide

Z9264F-ON switch installation

To install the Z9264F-ON switch, complete the installation procedures in the order presented in this chapter.

Always handle the switch and components with care. Avoid dropping the switch or its field replaceable units (FRUs).

NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap

when handling the Z9264F-ON switch and components. As with all electrical devices of this type, take all the necessary

safety precautions to prevent injury when installing this switch.

Topics:

• Unpack

• Ground lug assembly

• Four-post rack assembly

• Four-post rack mount

• 2RU front-rack installation

• Optics installation

• Switch start-up

• Switch replacement

• After switch placement

Unpack

NOTE:

Before unpacking the switch, inspect the container and immediately report any evidence of damage.

When unpacking the switch, ensure that the following items are included:

• One Z9264F-ON switch

• One RJ-45 to DB-9 female cable

• Two sets of rail kits, no tools required

• Two PSUs

• Four fan units

• Two AC power cables, country or region specific

• DC switches only: DC power ground lug kit

• Z9264F-ON Setup Guide

• Safety and Regulatory Information

• Warranty and Support Information

Unpacking steps

Unpack the switch carefully.

1. Place the container on a clean, flat surface and cut all straps securing the container.

2. Open the container or remove the container top.

3. Carefully remove the switch from the container and place it on a secure and clean surface.

4. Remove all packing material.

5. Inspect the product and accessories for damage.

Z9264F-ON switch installation 19