Install Guide

• No flow control

MicroUSB-B console port access

The MicroUSB-B console port is on the I/O side of the switch.

NOTE: The Z9264F-ON switch uses the Silicon Labs CP2109 USB-B chip. To find the correct USB-B universal

asynchronous receiver-transmitter (UART) driver, see https://www.silabs.com/products/development-tools/

software/usb-to-uart-bridge-vcp-drivers.

The terminal settings are the same for the serial console port and the RS-232/RJ-45 console port:

• 115200 baud rate

• No parity

• Eight data bits

• One stop bit

• No flow control

When you connect the microUSB-B port, it becomes the primary connection and, while connected, all messages are sent to the

microUSB-B port.

NOTE: Before starting this procedure, be sure that you have a terminal emulation program that is already installed on

your computer. To download Dell EMC drivers, see www.dell.com/support. If your computer requires non-Dell EMC

drivers, contact Dell EMC technical support for assistance.

1. Start up the computer.

2. Connect the USB-A end of cable into an available USB port on the computer.

3. Connect the microUSB-B end of cable into the microUSB-B console port on the switch.

4. Start up the switch.

5. Install the necessary USB device drivers.

To download Dell EMC drivers, see www.dell.com/support. If your computer requires non-Dell EMC drivers, contact Dell EMC

technical support for assistance.

6. Open your terminal software emulation program to access the switch.

7. Confirm that the terminal settings on your terminal software emulation program are as follows:

• 115200 baud rate

• No parity

• Eight data bits

• One stop bit

• No flow control

USB storage mount

USB storage does not automatically mount. USB storage supports the FAT file system. To use USB storage, first mount the device using

the following steps:

1. Create a mount directory for the USB storage.

ONIE:/ # mkdir /mnt/usb

2. View the fixed disks using the fdisk command.

ONIE:/mnt # fdisk -l

For internal storage:

Disk /dev/sda: 15.8 GB, 15829303296 bytes

255 heads, 63 sectors/track, 1924 cylinders

Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot Start End Blocks Id System

/dev/sda1 1 1925 15458303+ ee EFI GPT

Management ports