Install Guide

Parameter Specifications
Operating humidity 5% to 90% (RH), non-condensing
Storage temperature –40°C to 70°C (–40°F to 158°F)
Storage humidity 5% to 90%, non-condensing
Maximum thermal output 470 W = 1603.7 BTU/Hr
Maximum operational altitude 5,000 feet (1,524 meters)
Maximum non-operational altitude 39,370 feet (12,000 meters)
Shock Dell EMC Spec SV0115
Table 7. AC power requirements
Parameter Specifications
Power supply 100–240 VAC 50/60 Hz
Maximum current draw per switch 4.7A/3.9A at 100/120V AC 2.35A/1.95A at 200/240V AC
Maximum power capability 1104.37W (based on 4.5W QSFP28)
Typical power consumption 900W
Table 8. DC power requirements
Parameter Specifications
Minimum/maximum input voltage range -48V, –60V
Input power at full load −48V/930W, −60V/950W (without fan)
−48V/940W −60V/ 960W, with fan
Input current at full load −48V/19.0A −60V/ 15.6A, without fan
−48V/19.2A −60V/ 16.0A, with fan
IEEE standards
The Z9264F-ON switch complies with the following IEEE standards.
• 802.1ab (LLDP)
• 802.1ax (Layer 2)
• 802.1d, 802.1w, 802.1s, 802.1x (Mgmt/Security), 802.3x (Layer 2)
• 802.3 (1000BASE-KX)
• 802.3ba (40GbE and 100GbE ports)
Agency compliance
The Z9264F-ON switch is designed to comply with the following safety and agency requirements:
USA Federal Communications Commission FCC
statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own
expense.
38
Specifications