Owners Manual
Parameter # Parameter data
[5:8]—Ending IP address that is blocked or
unblocked based on the state.
For example, if the IP address is x1.x2.x3.x4,
the format is:
1st byte = x1
2nd byte = x2
3rd byte = x3
4th byte = x4
Remove the IPv4 port number rule 6 Data 1:—Protocol TCP/UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:3—port number
[2:3]—Port number from the ports blocked
or unblocked based on the state.
Remove the IPv4 port range rule 7 Data 1:—Protocol TCP and UDP
0 = TCP
1 = UDP
2 = both TCP and UDP
Data 2:5—port range
[2:3]—Port number from the ports blocked
or unblocked based on the state.
[4:5]—Port number till ports are blocked or
unblocked based on the state.
Flush IPv4 and IPv6 iptable 8 Flush all the rules set using iptables and
ip6tables.
Drop all 9 Add iptables rules to block IPv4 and IPv6
trac to the BMC. The state selector is not
used.
Data1: Protocol
Bit 7:2—Reserved
Bit 1—IPv6
Bit 0—IPv4
Remove drop all rule 10 Remove iptables rules to block IPv4 and
IPv6 trac to the BMC. The state selector
is not used.
Data1: Protocol
Conguration methods 17