Getting Started With Your PowerVault™ 124T PowerVault™ 124T מתחילים לעבוד עם *X5MJV* X5MJV www.dell.com | support.dell.
Information in this document is subject to change without notice. © 2012 Dell Inc. All rights reserved. Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell, the DELL logo, and PowerVault are trademarks of Dell Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. Linux is a registered trademark of Linus Torvalds. NetWare is a registered trademark of Novell, Inc.
Warning: Before performing the following procedure, read and follow the safety instructions in your Safety, Environmental and Regulatory information guide located in the box containing the PowerVault 124T. Installation and Configuration See the PowerVault 124T User’s Guide located on http://support.dell.com for detailed information on the installation and configuration of your system.
Unpack your system and accessories. Save all shipping materials in case you need them later. (Your system may not include all of the accessories shown.) 1. SAS cable 2. Power cable 3. Quick Start Guide 4. Magazine release tool 5. Magazine blank 6. Bar code labels 7. TORX L-key drivers (T8, T10) Install the PowerVault 124T in a rack. See your rack installation documentation for instructions on installing your PowerVault 124T in a rack. For more information on PowerEdge Racks, visit www.dell.com. .
Establish the SAS and network connections. Connect the Ethernet cable (1), SAS cable (2) and power cable (3). Connect the system to power. NOTE: Be certain that the host server is powered off before connecting the autoloader. Connect the system’s power cable(s) to the system. Next, plug the other end of the cable into a grounded electrical outlet or a separate power source such as an uninterruptible power supply (UPS) or a power distribution unit (PDU).
Verify robot/drive seen by operating system. Microsoft Windows : Under Device Manager, an unknown media changer should be present. Under Tape Drive, you should see the drive that is configured for your autoloader. ® ® Linux: You can use the drive through the standard /dev/st0 and tar or dd but will have to load the cartridge manually. Netware: You must enable LUN scanning for some backup software. Configure the PowerVault 124T. The default IP address is 192.168.20.128. .
