Specifications

Figure 35. Command > Move > Position Picker Dialog
To choose one of the four selections, follow the steps.
NOTE: The column, magazine, and slot parameter selections are interactive. The combination of the three parameters generates the
element address.
Step 1 Press the button beneath the desired softkey.
l If the button beneath the OK softkey is pressed, the source parameters are accepted and the picker moves to the chosen element
address location.
l If the button beneath the Change Column softkey is selected, the column indicator is stepped clockwise to the next column address.
Repeat until the desired column is indicated.
l If the button beneath the Next softkey is selected, the current source parameter changes from column to magazine and the Change
Magazine Dialog is displayed. Refer to Figure 36.
l If the button beneath the Cancel softkey is pressed, the Move Submenu is displayed.

Figure 36. Command > Move > Position Picker > Change Magazine Dialog
To choose one of the four selections, follow the step.
Step 2 Press the button beneath the desired softkey.
l If the button beneath the OK softkey is pressed, the source parameters are accepted and the picker moves to the chosen element
address location.
l If the button beneath the Change Magazine softkey is selected, the magazine indicator is stepped downward to the next magazine
address. Repeat until the desired magazine is indicated.
l If the button beneath the Next softkey is selected, the current source parameter changes from magazine to slot and the Change Slot
Dialog is displayed. Refer to Figure 37.
NOTE: If the chosen column element is a drive (column 3), no slot or magazine parameters are available. The menu will revert from the
drive parameter back to the change column parameter.
l If the button beneath the Cancel softkey is pressed, the Move Submenu is displayed.

Figure 37. Command > Move > Position Picker > Change Slot Dialog
To choose one of the four selections, follow the step.
Step 3 Press the button beneath the desired softkey.
l If the button beneath the OK softkey is pressed, the source parameters are accepted and the picker moves to the chosen element
address location.
l If the button beneath the Change Slot softkey is selected, the slot indicator is stepped downward to the next slot address. Repeat until the
desired slot is indicated.
l If the button beneath the Next softkey is selected, the current source parameter changes from slot to column as shown in the Position
Picker Dialog. Refer to Figure 35.
l If the button beneath the Cancel softkey is pressed, the Move Submenu is displayed.
Scan Barcode Dialog