Manual

3-8 Installation and Troubleshooting Guide
Time-of-day not set -
please run SETUP program
Incorrect Time or Date settings
or defective system battery
Check the Time and Date set-
tings. See Chapter 3, “Using the
System Setup Program,” in the
User's Guide for instructions. If
the problem persists, replace the
system battery. If the problem
still persists, replace the I/O
board. See Chapter 9, “Getting
Help,” for instructions on obtain-
ing technical assistance.
Timer chip counter 2
failed
Defective system board Replace the system board. See
Chapter 9, “Getting Help,” for
instructions on obtaining technical
assistance.
Unexpected interrupt in
protected mode
Improperly seated DIMMs or
faulty keyboard/mouse controller
chip (defective system board)
Remove and reseat the DIMMs.
If the problem persists, replace
the DIMMs. If the problem still
persists, replace the system
board. See Chapter 9, “Getting
Help,” for instructions on obtain-
ing technical assistance.
Unsupported CPU detected
in SLOT n
Unsupported CPU speed
detected!
Microprocessor not supported by
system
Install a correct version of the
microprocessor in the specified
microprocessor connector.
Unsupported CPU speed in
CMOS
Microprocessor not supported by
BIOS
Upgrade the BIOS. See
Chapter 3, “Using the System
Setup Program,” in the
User's
Guide
for instructions.
Unsupported DIMM
installed in the RAID
DIMM slot!
RAID DIMM not supported by
system
This DIMM slot is not supported.
Remove the DIMM.
Write fault
Write fault on selected
drive
Faulty diskette or hard-disk drive Replace the diskette or hard-disk
drive.
Table 3-1. System Messages (continued)
Message Cause Corrective Action
NOTE: For the full name of an abbreviation or acronym used in this table, see “Abbreviations and Acronyms.”
87MPGbk0.book Page 8 Wednesday, December 13, 2000 2:14 PM