Manual

support.dell.com Checking Inside the System 6-5
Figure 6-3. Removing the Expansion-Card Cage
4. Locate the expansion-card cage securing lever (see Figure 6-3). Rotate the lever
upward until it stops in an upright position.
5. Lift the expansion-card cage up and away from the chassis.
Replacing the Expansion-Card Cage
To replace the expansion-card cage, perform the following steps:
1. With the securing lever in the upright position, lower the expansion-card cage
into place until it is aligned.
2. Rotate the securing lever downward until it is flush with the top of the chassis.
Make sure the riser board is fully seated in the RISER connector on the system
board.
3. Reconnect any cables you removed in step 3 of the previous procedure, “Remov-
ing the Expansion-Card Cage.”
Inside the Chassis
In Figure 6-4, the system doors are opened to provide an interior view. Refer to this
illustration to locate interior features and components discussed later in this guide.
securing lever
expansion-card cage
power LED
87MPGbk0.book Page 5 Wednesday, December 13, 2000 2:14 PM