User guide

Figure 1-9. Removing the Feet and the System Cover
. foot (4)
hex-head
Phillips
screw (4)
b Slide the system eover baek and grasp the eover at both ends,
c Carefully lift the eover away from the system and set it aside.
3 Remove the eosmetie trim panels on the left side of the ehassis:
a Remove the seven T-10 Torx serews from the top, left, and bottom edge of the
front panel.
These seven serews seeure the eosmetie trim panel to the front panel and ehassis.
b Slide the eosmetie trim panel about 0.5 ineh toward the baek of the ehassis and
lift it away.
5 Remove the 12 remaining T-10 Torx serews that seeure the tower front panel to the
ehassis.
6 Lift the front panel away and set it aside, out of the way.
Installing the Rack Front Panel and Bezel
1 Install the гаек front panel on the ehassis, seeuring it with 13 of the Torx serews you
removed in the previous proeedure (see Figure 1-10).
Notiee that the raek front panel is wider than the tower front panel and has handles
and thumbserews for the front vertieal rails.
Rack Installation Guide | 1-13