Storage System Hardware Owner's Manual
Table Of Contents
- Hardware Owner’s Manual
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Bezel
- Opening and Closing the System
- Hard Drives
- Replacing a Hard-Drive Carrier
- Power Supplies
- System Fans
- Cooling Shroud
- Fan Brackets
- Cable Routing
- SAS Controller Daughter Card
- Configuring the Boot Device
- Expansion Cards
- Expansion-Card Cage
- DRAC Card and Cables
- Optical Drive and Cable
- System Memory
- Activating the Integrated NIC TOE
- Processors
- System Battery
- Expansion-Card Riser Boards
- Sideplane Board
- SAS Backplane Board
- Control Panel Assembly (Service-only Procedure)
- System Board (Service-only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Basic I/O Functions
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS Controller Daughter Card
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
Installing System Components 119
NOTE: To properly reinstall the hard drives, ensure that you record which
hard drive you remove from which bay.
5
Disconnect the SAS cable(s) and control panel cable from the backplane
connectors. See "SAS Controller Daughter Card Cabling Guidelines" on
page 87 and "Removing the Control Panel Assembly" on page 122.
6
If applicable, remove the storage controller daughter card. See "Removing
a SAS Controller Daughter Card" on page 87.
7
Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 80.
8
Remove the fans. See "Removing a System Fan" on page 78
9
Remove the fan bracket. See "Removing the Fan Bracket" on page 81.
10
Remove the SAS backplane board:
a
Pull the SAS-backplane board release pin. See Figure 3-26.
b
While pulling the release pin, tilt the backplane board toward the back
of the system.
c
Lift the backplane board from its securing tabs and remove the
backplane board from the chassis.
Book.book Page 119 Monday, September 14, 2009 12:57 PM