Storage System Hardware Owner's Manual

Installing System Components 67
Opening the System
To upgrade or troubleshoot the system, remove the system cover to gain
access to internal components.
1
Unless you are installing a hot-plug component such as a cooling fan or
power supply, turn off the system and attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2 To remove the system cover, turn the latch release lock counter-clockwise
to the unlocked position. See Figure 3-3.
3 Lift up on the latch on top of the system. See Figure 3-3.
4 Grasp the cover on both sides and carefully lift the cover away from the
system.
Closing the System
1 Lift up the latch on the cover.
2 Place the cover on top of the system and offset the cover slightly back so
that it clears the chassis J hooks and lays flush on the system chassis. See
Figure 3-3.
3 Push down the latch to lever the cover into the closed position.
4 Rotate the latch release lock in a clockwise direction to secure the cover.
Book.book Page 67 Monday, September 14, 2009 12:57 PM