User Manual
100 Installing System Components
4
If a diskette drive ribbon cable is already connected to your system board,
skip to the next step. Otherwise, do the following:
a Disconnect the cables from the SAS controller daughter card on the
expansion-bay bracket and pull the cables out of the way of the
center fan
bracket.
b Remove the fans from the center fan bracket. See
"Removing and
Installing a Fan" on page 83
.
c Remove the center fan bracket. See
"Removing the Center Fan
Bracket" on page 105
.
5
To remove the diskette drive filler plate, pull the retention spring slightly
away from the filler plate, then lift the filler plate from the carrier.
6
Install the diskette drive carrier into the system:
a
Align the slots on the bottom of the diskette drive carrier with the
drive bay tabs on top of the peripheral bay and lower the carrier unto
the tabs.
b
Push the carrier toward the system front plate until the plastic latch
on the carrier locks into position.
7
Attach one end of the ribbon cable to the floppy connector on the system
board and the other end to the connector on the rear of the diskette drive.
8 Attach the power cable to the floppy connector (FDD) at the top of the
SAS backplane board
(see Figure 6-3) a
nd to the power connector on the
rear of the diskette drive.
9
If applicable, replace the components you removed in step 4:
a Replace the center fan bracket. See
"Replacing the Center Fan
Bracket" on page 106
.
b
Replace the fans into the center fan bracket.
c Reconnect the cables to the SAS controller daughter card.
10 Close the system. See
"Closing the System" on page 68
.
11 Replace the front bezel, if removed in
step 2
.
12
Reconnect the system and peripherals to their electrical outlets.
book.book Page 100 Monday, September 14, 2009 1:53 PM