User Manual

Using the System Setup Program 53
Diskette Controller
(Auto default)
Enables or disables the system's diskette drive controller. When
Auto is selected, the system turns off the controller when
necessary to accommodate a controller card installed in an
expansion slot. You can also configure the drive as Read-Only, or
Off. When using the Read-Only setting, the drive cannot be
used to write to a disk.
User Accessible
USB Ports
(All Ports On
default)
Enables or disables the system’s user accessible USB ports.
Options are All Ports On, Only Back Ports On, and All Ports
Off.
Embedded Gb
NIC1
(Enabled with
PXE default)
Enables or disables the system's integrated NIC1. Options are
Enabled without PXE, Enabled with PXE, and Disabled. PXE
support allows the system to boot from the network. Changes
take effect after the system reboots.
MAC Address Displays the MAC address for the integrated 10/100/1000 NIC.
This field does not have user-selectable settings.
TOE Capability Displays the TCP/IP Offload Engine (TOE) feature status of
NIC1.
Embedded Gb
NIC2
(Enabled without
PXE default)
Enables or disables the system's integrated NIC2. Options are
Enabled without PXE, Enabled with PXE, and Disabled. PXE
support allows the system to boot from the network. Changes
take effect after the system reboots.
MAC Address Displays the MAC address for the integrated 10/100/1000 NIC.
This field does not have user-selectable settings.
TOE Capability Displays the TOE feature status of NIC2.
Table 2-4. Integrated Devices Screen Options (continued)
Option Description
book.book Page 53 Monday, September 14, 2009 1:53 PM