Manual

30 Installing Enclosure Components
Figure 3-2. Installing and Removing Physical Disks
4 Open the physical disk carrier handle by rotating it downward.
5 Gently but firmly pull the physical disk carrier from its slot while
supporting the weight of the
physical disk from the bottom.
Installing Physical Disks in the Enclosure
NOTICE: To ensure proper airflow for enclosure cooling, each slot should contain
either an active physical disk or a physical disk blank.
NOTICE: Always wear a wrist grounding strap when handling equipment with
static-sensitive components.
Perform the following steps to install the new physical disk into the carrier:
1
Remove the four screws that secure the physical disk to its carrier and
remove the
physical disk (see Figure 3-3).
2 Position the replacement physical disk into the physical disk carrier with
the disk's controller board facing down as shown in Figure 3-3.
3 Align the physical disk mounting holes with the SAS carrier mounting
holes as shown in Figure 3-3.
1 carrier release mechanism 2 physical disk carrier handle
1 2