User Manual

3 Click OK , then choose Yes to accept the warning message.
The RAID controller module should now be offline.
Removing a RAID Controller Module
1 Remove all data cables from the RAID controller module.
2 Push up on the release tab on the left side of the module (see Figure 1).
3 At the same time, pull out on the release lever. When the lever is pulled
out, the controller module partially ejects from the
enclosure .
4 Remove the module from the enclosure and place it on a flat,
secure surface.
NOTICE: To avoid damage to the sensitive EMI contacts on the bottom
of the controller module, do not stack or place it on a hard surface.
Figure 1. Removing and Installing a RAID Controller Module
1 release tab 2 release lever
2
1