Release Notes

Configuring Volume Mount Point in Dell Failover
Clusters Running Windows Server 2008
Operating System
To configure a volume mount point in a Dell Failover Cluster running Windows
Server 2008 operating system:
1
Initialize the logical disk created for configuring the volume mount point.
2 Add the logical disk you initialized in step 1 to the Available Storage pool in
the cluster:
a Open the Failover Cluster Management Console .
b Right-click the Storage in the cluster.
c Click Add a disk .
d Select the disk and click OK .
3 Create the partition and mount point on the disk using the Disk
Management Console
.
4 Configure the cluster disk dependency using Failover Cluster Management
Console
.
__________________
Information in this document is subject to change without notice.
©2008 Dell Inc. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and PowerVault are trademarks of Dell Inc.; Microsoft,
and Windows Server are either trademarks or registered trademarks of Microsoft Corporation in the United
States and/or other countries.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the
marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade
names other than own.
April 2008 Rev. A00
MDiSCSI.fm Page 12 Monday, April 21, 2008 2:17 PM