Reference Guide

Troubleshooting 67
You are prompted to
configure one network
instead of two during
MSCS installation.
The TCP/IP
configuration
is incorrect.
The node-to-node network and
public network must be assigned
static IP addresses on different
subnets. See "Assigning Static IP
Addresses to Cluster Resources
and Components" for
information about assigning the
network IPs.
The private (point-to-
point) network is
disconnected.
Ensure that all systems are
powered on so that the NICs in
the private network
are available.
Unable to add a node to
the cluster.
The new node cannot
access the shared
disks. The shared disks
are enumerated by the
operating system
differently on the
cluster nodes.
Ensure that the new cluster
node can enumerate the cluster
disks using Windows Disk
Administration. If the disks do
not appear in Disk
Administration, check the
following:
• Check all cable connections
• For Fibre Channel storage
arrays, check all zone
configurations
• Check the Access Control
settings on the attached
storage systems. Verify that
the node in question is a
member of the correct Storage
Group or Host Group.
• Use the "Advanced" with
"Minimum" option
Table A-1. General Cluster Troubleshooting (continued)
Problem Probable Cause Corrective Action