Owner`s manual

Back-Panel Connectors (Per RAID Controller

Module)

Two SAS OUT ports, it is recommended that you

use the first port for expansion to an additional

PowerVault MD3060e expansion enclosure. Only

one expansion port is supported at any given time.

NOTE: SAS connectors are SFF-8644

compliant.

Serial connector (debug port)

One 6-pin mini serial port

NOTE: For technical support use only.

Management Ethernet connector One 100/1000 Mbps Ethernet connection for out-

of-band management of the enclosure and the

second Ethernet port is reserved.

Power

AC power supply (per power supply)

Wattage 1755 W

Heat dissipation (maximum)

NOTE: Heat dissipation is calculated

using the power supply wattage rating.

The heat dissipation values are for the

entire system which includes chassis and

two controllers.

5988 BTU/hr

Voltage

NOTE: This system is also designed to be

connected to IT power systems with a

phase to phase voltage not exceeding

230 V.

220 V AC, autoranging, 50 Hz/60 Hz

Battery 6.6 V DC, 1100 mAh, 7.26 W Lithium ion battery

Environmental

NOTE: For additional information about environmental measurements for specific system

configurations, see dell.com/environmental_datasheets.

Temperature

Operating Continuous operation: 10 °C to 35 °C (50 °F to 95 °F) at

20% to 80% relative humidity (RH), with 26 °C

maximum dew point. De-rate maximum allowable dry

bulb temperature at 1 °C/300 m (1 °F per 550 ft) above

900 m (2952.75 ft).