Administrator Guide

• Select A new snapshot image (on an existing snapshot group) and then a snapshot group from the existing snapshot group
table and then click Next.
The Snapshot Virtual Disk Settings window is displayed.
4. In the Snapshot virtual disk name field, enter a unique name (30 character maximum) that best describes the virtual disk selected
for this snapshot image, for example, AccountingData.
By default, the snapshot virtual disk name is shown in the name text box as follows:[base-virtual disk-name] - SV +
sequence-number
In this example, SV (snapshot virtual disk) is the appended suffix and sequence-number is the chronological number of the snapshot
virtual disk relative to the base virtual disk.
For example, if you create the first snapshot virtual disk for a base virtual disk called “Accounting”, the default name of the snapshot
virtual disk is “Accounting_SV_01”. The default name of the next snapshot virtual disk you create based on “Accounting” is
“Accounting_SV_02”.
There is a 30-character limit. After you reach this limit, you can no longer type in the text box. If the base virtual disk is 30 characters,
the default name for the group uses the base virtual disk name truncated enough to add the suffix “SV” and the sequence string.
5. In the Map to host drop-down, specify how you want to map the host to the snapshot virtual disk.
• Map Now to Default Group – The virtual disk is automatically assigned a logical unit number (LUN) and is accessible by any
hosts that are connected to the storage array.
• Map Later – The virtual disk is not assigned a LUN and is not accessible by any hosts until you go to the Host Mappings tab and
assign a specific host and LUN to this virtual disk.
• Select a specific host – You can select a specific host or host group from the list. This option is available only if Storage
Partitioning is enabled.
NOTE:
Make sure there are enough free LUNs on the host or host group that you selected to map to a snapshot
virtual disk.
6. Select how to grant host access to the snapshot virtual disk. Do one of the following:
• Select Read Write and go to step 7.
• Select Read Only and click Finish to create the snapshot virtual disk. Go to step 8.
NOTE: Repositories are not required for Read Only snapshot virtual disks.
Keep these guidelines in mind when you grant host access to a snapshot virtual disk:
• Each host has its own logical unit number (LUN) address space and allows the same LUN to be used by different host groups or
hosts to access snapshot virtual disks in a storage array.
• You can define one mapping for each snapshot virtual disk in the storage array.
• Mappings are shared between controllers in the storage array.
• The same LUN cannot be used twice by a host group or a host to access a snapshot virtual disk. You must use a unique LUN.
• An access virtual disk mapping is not required for out-of-band storage arrays.
7. Choose how you want to create the repository for the Read-Write snapshot virtual disk. Do one of the following:
• Select Automatic and click Finish to create the snapshot virtual disk repository with the default capacity settings. This option is
the recommended one.
• Select Manual and click Next to define the properties for the snapshot virtual disk repository. Then click Finish to continue with
the snapshot virtual disk creation procedure.
Use this option if you want to specify all the customizable settings for the snapshot virtual disk repository. The Manual method is
considered advanced and only those who understand physical disk consistency and optimal physical disk configurations should use this
method.
8. Click Finish.
The snapshot virtual disk and its properties under the individual virtual disk node for the associated base virtual disk is displayed in the
navigation tree. The snapshot virtual disk is added as a new virtual disk that contains the snapshot image information, which is the
data of the virtual disk at the particular time of snapshot image creation.
Creating a Snapshot Virtual Disk repository
When you create a snapshot virtual disk that is designated as read-write, a snapshot virtual disk repository is created to provide the host
application with write access to a copy of the data contained in the snapshot image. You can create the repository automatically using the
default settings or you can manually create the repository by defining the capacity settings for the repository.
Premium feature—Snapshot Virtual Disk
115