Laptop User Manual

Configuration: About Your Storage Array 81
9 For the selected e-mail address, in Frequency , select:
•
Every event —Sends an alert e-mail whenever an event occurs. This is
the default option.
•
Every x hours —Sends an alert e-mail after the specified time interval
if an event occurred during that time interval. You can select this
option only if you have selected either
Event + Profile or Event +
Support
in the Information To Send drop down list.
10 Click OK .
An alert icon appears next to each node in the Tree view where an alert is set.
To ensure that the e-mail is sent successfully:
• You must provide a SMTP mail server name and an e-mail sender address
for the e-mail addresses to work.
• The e-mail addresses that you had previously configured appear in the
Configured e-mail addresses area.
• You must use fully qualified e-mail addresses, for example,
[e-mail].
• You can configure multiple e-mail addresses before you click
OK .
Configuring SNMP Alerts
To add a management console to the list of addresses configured to receive
SNMP alerts:
1
Open the Configure Alerts dialog by performing one of these actions:
• In the Tree view or the Table view on the
Devices tab in the EMW,
select a node, and select
Edit  Configure Alerts . Go to step 3.
•In the
Setup tab in the EMW, select Configure Alerts. Go to step 2.
2 Select one of the following radio buttons to specify an alert level:
•
All storage arrays —Select this option to send an alert notification
about events on all storage arrays.
•
An individual storage array —Select this option to send an alert
notification about events that occur in only a specified storage array.
book.book Page 81 Wednesday, June 8, 2011 5:01 PM