Setup Guide
Table Of Contents
- Getting Started With Your System
- Getting Started With Your System
- Before You Begin
- Other Documentation and Media You May Need
- Supported Operating Systems
- Common Configurations
- Installation and Configuration
- Unpacking the System
- Installing the Rails and System in a Rack
- Connecting the Power Cable(s)
- Securing the Power Cable(s)
- Installing and Removing SFP Modules
- Installing and Removing Fibre Channel Cables
- Cabling Your Expansion Enclosure
- Turning On the Storage Array
- Installing the Bezel
- Installing HBAs and Drivers
- Installing the MD Storage Software
- Locating Your Service Tag
- NOM Information (Mexico Only)
- Technical Specifications
- 系统使用入门
- Memulai Pengaktifan dengan Sistem Anda
- Sebelum Anda Mulai
- Dokumen dan Media Lain yang Mungkin Anda Butuhkan
- Sistem Pengoperasian yang Didukung
- Konfigurasi Standar
- Instalasi dan Konfigurasi
- Membuka Kemasan Sistem
- Memasang Rel dan Sistem dalam Rak
- Menyambungkan Kabel Daya
- Menahan Kabel Daya
- Memasang dan Melepaskan Modul SFP
- Memasang dan Melepaskan Kabel Fibre Channel
- Mengatur Kabel Expansion Enclosure Anda
- Mengaktifkan Storage Array
- Memasang Bezel
- Memasang HBA dan Driver
- Menginstal Perangkat Lunak MD Storage
- Menemukan Tag Servis Anda
- Informasi NOM (Hanya Meksiko)
- Spesifikasi Teknis
- はじめに
- 시스템 시작 안내서
Getting Started With Your System
13
3
MD3600f series
storage array
NOTE:
Before turning on the host server(s), ensure that the storage array
status LED is blue.
4
Host server(s)
Installing the Bezel
Install the bezel (optional).
Installing HBAs and Drivers
NOTE:
Ensure that you read the Configuring Fibre Channel With the Dell MD3600f
Series Storage Array document before continuing with this procedure. For detailed
instructions about installing the MD storage software, setting up the enclosure, and
the post-installation tasks, see the Deployment Guide.
1
Physically install the HBAs.
2
Connect the cables.
3
Install the HBA drivers and the operating system HBA patches/hotfixes.
4
Ensure that the recommended HBA settings are applied.