Reference Guide

Parameters
Parameter Description
physicalDisks
The physical disks you want to assign to the disk
pool. Enclosure ID values are 0 to 99; drawer ID
values are 0 to 4; slot ID values are 0 to 31.
NOTE: A disk pool must contain at least 11
physical disks.
physicalDiskType
Physical disk type value is sas. Enclose the
physical disk type values in parentheses. If the
physical disk type is specified, then all of the
unassigned physical disks of that type that are
compatible with each other are used for the
creation of the disk pool.
physicalDiskCount
The physicalDiskCount parameter limits the
disk pool candidates to the given number. Use this
parameter only when the physicalDiskType
parameter is specified.
reservePhysicalDiskCount
The default value is automatically determined by
the controller. This value is specified in terms of
the number of physical disks to reserve in the disk
pool for physical disk failures or physical disk
removals.
warningThreshold
The percentage of storage capacity at which you
receive a warning alert that the disk pool is nearing
full capacity. Use integer values. For example, a
value of 60 means 60 percent. The default value is
50.
Setting this parameter to 0 disables warning alerts.
If you set this to default, the warning alert
threshold value is determined by the controller
firmware.
criticalPriority
The default value is highest.
backgroundPriority
The default value is low.
securityType
The setting to specify the security level when
creating the disk pool. All virtual disk candidates for
the disk pool have the specified security type.
These settings are valid:
• none—The virtual disk candidates are not
secure.
• capable—The virtual disk candidates are
capable of having security set, but security has
not been enabled.
165