Reference Guide

Parameters
Parameter Description
asyncRemoteReplicationGroup
The name of the remote replication group that you
want to modify. Enclose the virtual disk name in
square brackets ([ ]). If the virtual disk name has
special characters, you also must enclose the
virtual disk name in double quotation marks (" ")
inside square brackets. If the virtual disk name
consists only of numbers, such as "1002," you also
must enclose the virtual disk name in double
quotation marks (" ") inside square brackets.
syncInterval
Specify the length of time between automatically
sending updates of modified data from the local
storage array to the remote storage array. You can
specify the length of time in minutes, hours, or
days.
warningSyncThreshold
Specify the length of time to wait until a warning is
triggered for cases in which the synchronization of
all of the virtual disks within the remote replication
group takes longer than the defined time. You can
specify the length of time in minutes, hours, or
days.
warningRecoveryThreshold
Specify the length of time to wait until a warning is
triggered when the automatic data update for the
point-in-time image on the remote storage array is
older than the defined time. Define the threshold
from the end of the previous update. You can
specify the length of time in minutes, hours, or
days.
NOTE: You must set the Recovery Point
Threshold to be twice as large as the
synchronization interval threshold.
warningThresholdPercent
Specify the percent value that determines when a
warning is triggered when the capacity of a
replication repository virtual disk reaches the
defined percentage. Define the threshold by
percentage (%) of the capacity remaining.
userLabel
The new name that you want to give to the remote
replication group. Use this parameter when you
want to rename the remote replication group.
Enclose the new remote replication group name in
double quotation marks (" ").
autoResync
The settings for automatic resynchronization
between the primary virtual disks and the
289