Manualshelf

Laptop User Manual

ManualsBrandsDell ManualsComputer HardwarePOWERVAULT MD3620F
121122123124125126127128129130
Table Of Contents
126 Configuration: Disk Groups and Virtual Disks
Modifying and Removing Host-to-Virtual Disk Mapping
You can modify or remove a host-to-virtual disk mapping for several reasons,
such as an incorrect mapping or reconfiguration of the storage array.
Modifying or removing a host-to-virtual disk mapping applies to both hosts
and host groups.
To modify or remove host to virtual disk mapping:
NOTE: Before you modify or remove a host-to-virtual disk mapping, you must stop
any data access (I/O) to the virtual disks to prevent data loss.
1
In the AMW, select the
Mappings
tab.
2
In the
Defined Mappings
pane, perform one of these actions:
• Select a single virtual disk, and select
Mappings

Change
Mapping.
• Right-click the virtual disk, and select
Change Mapping
from the
pop-up menu.
3
In
Host group or host,
select the appropriate host group or host.
By default, the drop-down list shows the current host group or the host
associated with the selected virtual disk.
4
In
Logical unit number
, select the appropriate LUN.
The drop down list shows only the currently available LUNs that are
associated with the selected virtual disk.
5
Click
OK
.
Stop any host applications associated with this virtual disk, and unmount
the virtual disk, if applicable, from your operating system.
6
In the
Change Mapping
dialog, click
Yes
to confirm the changes.
The mapping is checked for validity and is saved. The
Defined Mappings
pane is updated to reflect the new mapping. The
Topology
pane is also
updated to reflect any movement of host groups or hosts.
NOTE: If a password is set on the storage array, the Enter Password dialog
appears. Type the current password for the storage array, and click OK.
book.book Page 126 Wednesday, June 8, 2011 5:01 PM