Setup Guide
Table Of Contents
- Getting Started With Your System
- Getting Started With Your System
- Before You Begin
- Other Documentation and Media You May Need
- Supported Operating Systems
- Common Configurations
- Installation and Configuration
- Unpacking the System
- Installing the Rails and System in a Rack
- Connecting the Power Cable(s)
- Securing the Power Cable(s)
- Installing and Removing SFP Modules
- Installing and Removing Fibre Channel Cables
- Cabling Your Expansion Enclosure
- Turning On the Storage Array
- Installing the Bezel
- Installing HBAs and Drivers
- Installing the MD Storage Software
- Locating Your Service Tag
- NOM Information (Mexico Only)
- Technical Specifications
- 系统使用入门
- Memulai Pengaktifan dengan Sistem Anda
- Sebelum Anda Mulai
- Dokumen dan Media Lain yang Mungkin Anda Butuhkan
- Sistem Pengoperasian yang Didukung
- Konfigurasi Standar
- Instalasi dan Konfigurasi
- Membuka Kemasan Sistem
- Memasang Rel dan Sistem dalam Rak
- Menyambungkan Kabel Daya
- Menahan Kabel Daya
- Memasang dan Melepaskan Modul SFP
- Memasang dan Melepaskan Kabel Fibre Channel
- Mengatur Kabel Expansion Enclosure Anda
- Mengaktifkan Storage Array
- Memasang Bezel
- Memasang HBA dan Driver
- Menginstal Perangkat Lunak MD Storage
- Menemukan Tag Servis Anda
- Informasi NOM (Hanya Meksiko)
- Spesifikasi Teknis
- はじめに
- 시스템 시작 안내서
16
Getting Started With Your System
NOM Information (Mexico Only)
The following information is provided on the device described
in this document in compliance with the requirements of the
official Mexican standards (NOM):
Technical Specifications
Importer:
Model number: E03J and E04J
Supply voltage: 100–240 V CA
Frequency: 50/60 Hz
Current consumption: 8.6 A
Drives
PowerVault MD3600f Up to twelve 3.5" SAS hot-swappable hard drives
(3.0 Gbps and 6.0 Gbps)
PowerVault MD3620f Up to twenty four 2.5" SAS hot-swappable
hard drives (3.0 Gbps and 6.0 Gbps)
RAID Controller Modules
RAID controller modules
• One or two hot-swappable modules with
temperature sensors
• 2 GB of cache per controller
Back-Panel Connectors (Per RAID Controller Module)
FC connectors Four FC IN ports to connect hosts
One SAS OUT port for expansion to an additional
PowerVault MD12xx enclosure
NOTE:
The SAS connector is SFF-8088 compliant.
SAS connector
Serial connector One 6-pin mini-DIN connector
NOTE:
For technical support use only.