Owners Manual
Table Of Contents
- Dell PowerVault MD3260/3260i/3660i/3660f/3060e Storage Arrays Owner's Manual
- About Your System
- Controller Modules
- RAID Controller Modules
- MD3260 SAS RAID Controller Module Features And Indicators
- MD3260i iSCSI RAID Controller Module Features And Indicators
- MD3660i iSCSI RAID Controller Module Features And Indicators
- MD3660f Fibre Channel RAID Controller Module Features And Indicators
- Expansion Controller Modules
- Controller Module—Additional Features
- Storage Array Thermal Shutdown
- System Password Reset
- Installing System Components
- Troubleshooting Your System
- Safety First—For You And Your System
- Troubleshooting Storage Array Startup Failure
- Troubleshooting Loss Of Communication
- Troubleshooting An SFP Transceiver
- Troubleshooting External Connections
- Troubleshooting Power Supply Modules
- Troubleshooting Array Cooling Problems
- Troubleshooting Expansion Enclosure Management Modules
- Troubleshooting RAID Controller Modules
- Troubleshooting Physical Disks
- Troubleshooting Array And Expansion Enclosure Connections
- Troubleshooting A Wet Storage Array
- Troubleshooting A Damaged Array
- Controller Failure Conditions
- Technical Specifications
- Getting Help
3
Installing System Components
Recommended Tools
You may need the following items to perform the procedures in this section:
• #2 Phillips screwdriver
• T8 and T15 Torx screwdrivers
• Wrist grounding strap connected to ground
Removing And Installing The Front Bezel
Installing The Front Bezel
You must install the front bezel on the system to secure the disk drawers against accidental removal.
1. Align the slots on the back of the bezel with the guide pins on the front of the chassis.
2. Push the bezel toward the chassis until the bezel is seated properly and the release latches snap into place.
Figure 15. Removing and Installing the Front Bezel
1. release latches (2)
2. front bezel
3. guide pins (4)
23