Owners Manual
Table Of Contents
- Dell PowerVault MD3260/3260i/3660i/3660f/3060e Storage Arrays Owner's Manual
- About Your System
- Controller Modules
- RAID Controller Modules
- MD3260 SAS RAID Controller Module Features And Indicators
- MD3260i iSCSI RAID Controller Module Features And Indicators
- MD3660i iSCSI RAID Controller Module Features And Indicators
- MD3660f Fibre Channel RAID Controller Module Features And Indicators
- Expansion Controller Modules
- Controller Module—Additional Features
- Storage Array Thermal Shutdown
- System Password Reset
- Installing System Components
- Troubleshooting Your System
- Safety First—For You And Your System
- Troubleshooting Storage Array Startup Failure
- Troubleshooting Loss Of Communication
- Troubleshooting An SFP Transceiver
- Troubleshooting External Connections
- Troubleshooting Power Supply Modules
- Troubleshooting Array Cooling Problems
- Troubleshooting Expansion Enclosure Management Modules
- Troubleshooting RAID Controller Modules
- Troubleshooting Physical Disks
- Troubleshooting Array And Expansion Enclosure Connections
- Troubleshooting A Wet Storage Array
- Troubleshooting A Damaged Array
- Controller Failure Conditions
- Technical Specifications
- Getting Help

5. raised buttons (2)
6. physical-disk carrier
7. release tab (12)
Installing A Physical Disk In A Physical-Disk Drawer
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. Rotate the physical-disk carrier handle upward to the vertical position.
2. Align the two raised buttons with the notches on the physical-disk drawer, lower the physical disk into the slot in
the physical-disk drawer.
NOTE: Ensure that you install the physical disk from left to right and from front to back.
3. Rotate the handle downward until the physical disk is properly seated in the connector and the physical-disk
carrier handle snaps into place.
4. Close the physical-disk drawer.
5. Install the front bezel.
SAS Chain Cables
There are two SAS cable chains on each side of the physical-disk drawer that connects the physical disks installed in
the physical-disk drawer to the midplane.
• The connector on each SAS chain cable that connects to the physical-disk drawer is oriented horizontally.
• The connector on each SAS chain cable that connects to the midplane is oriented vertically.
Figure 23. SAS Chain Cable Features
1. SAS cable connector on the physical-disk drawer (oriented horizontally)
2. SAS cable connector to the midplane (oriented vertically)
3. SAS chain cable (two per physical-disk drawer)
32