Users Guide

Figure 3. Réplication de plusieurs disques virtuels
Setting Up Remote Replication On The MD Storage Array
NOTE: You must activate the Remote Replication premium feature before performing the steps below. For step-by-
step instructions on using MD Storage Manager (MDSM) to set up Remote Replication, see the Administrator's
Guide for your array at dell.com/support/manuals.
Before installing and configuring SRM, you must set up Remote Replication on each MD storage array used in the
recovery solution.
NOTE: Setup of Remote Replication on iSCSI based PowerVault storage MD Series array is governed by iSCSI
array documents available on dell.com/support/manuals.
To set up Remote Replication on the storage array:
1. Start MD Storage Manager (MDSM) on your management host.
2. Open the Enterprise Management Window (EMW) and discover both the protected and recovery site's storage
array.
3. Open the Array Management Window (AMW) for the protected site's storage array and identify a virtual disk to be
used in the recovery solution.
4. Open the AMW for the recovery site's storage array and create a similar-sized, remotely replicated virtual disk.
5. Right-click on the protected site's storage array virtual disk and select Create Remote Replication
6. Select the settings appropriate for your environment and allow remote replication to synchronize.
7. Repeat these steps for:
a. Each virtual disk to be remotely replicated
b. Each storage array in the recovery solution
Configuration de la matrice Hôte à Stockage
Pour optimiser les performances et la gestion multivoie appropriées pour votre configuration, la structure de
commutateur et iSCSI connectant les sites d'hôte protégés et de récupération et les matrices de stockage doivent être
configurés correctement. Le schéma suivant illustre une configuration de base qui fournit une redondance complète :
9