Deployment Guide
Table Of Contents
- Dell EMC PowerVault MD3860f Series Storage Arrays Deployment Guide
- Introduction
- Hardware installation
- Planning the storage configuration
- Connecting the storage array
- Configuring Fibre Channel with Dell EMC MD Series storage arrays
- Configuring Fibre Channel on SAN attached storage arrays
- Other information you may need
- Installing supported Fibre Channel HBAs
- Using Fibre Channel switch zoning
- Cabling storage array
- SAN-attached cabling
- Cabling PowerVault MD3060e expansion enclosures
- Installing MD Storage Manager
- Post installation tasks
- Uninstalling MD Storage Manager
- Load balancing
- Appendix — Working with SFP modules and fiber optic cables
- Appendix — Hardware cabling best practices
- Getting help
Uninstalling MD Storage Manager from Linux
By default, PowerVault MD Storage Manager is installed in the /opt/dell/mdstoragemanager directory. If another
directory was used during installation, navigate to that directory before beginning the uninstallation procedure.
1. From the installation directory, open the Uninstall Dell MD Storage Software directory.
2. Run the file Uninstall Dell MD Storage Software.exe.
3. From the Uninstall window, click Next, and follow the instructions on the screen.
While the software is uninstalling, the Uninstall window is displayed. When the uninstall procedure is complete, the
Uninstall Complete window is displayed.
4. Click Done.
Uninstalling MD Storage Manager 25