Users Guide

Setting Up Your Cluster 19
Figure 2-4. PowerVault NX1950 Initial Configuration Tasks
NOTE: You can also access the PowerVault NX1950 Initial Configuration Tasks
wizard from the PowerVault NX1950 Management Console. To launch this wizard,
click Edit server configuration located in the right pane of the window as
highlighted in the Figure 2-1 below.
Creating the Cluster
The PowerVault NX1950 Initial Configuration Tasks wizard can be used to
create the cluster. Table 2-2 summarizes the steps for creating a cluster using
this wizard.
Table 2-2. Phases in Creating a Cluster
Step/Phase Node 1 Nodes 2-8
Start Cluster Configuration wizard ✓
Create the Quorum Disk ✓
Checking for Existing Cluster
Configuration
✓
Set the Cluster IP address ✓