Owners Manual

Installing System Components 89

Figure 3-7. Removing and Replacing a Redundant Power Supply

Installing a Redundant Power Supply

Verify that both power supplies are the same type and have the same

maximum output power.

NOTE: The maximum output power (shown in watts) is listed on the power supply

label.

Slide the new power supply into the chassis until the power supply is fully

seated and the release latch snaps into place. See Figure 3-7.

NOTE: If you unlatched the cable management arm in step 2 of the previous

procedure, relatch it. For information about the cable management arm, see the

system’s rack documentation.

CAUTION: When connecting the power cable, secure the cable with the

Velcro strap.

Connect the power cable to the power supply and plug the cable into a

power outlet.

1 power supply 2 locking tab

3 cable retention bracket

book.book Page 89 Thursday, August 13, 2009 7:27 AM