Deployment Guide

PowerVault FluidFS NAS Setup Worksheet
Complete the worksheet to record the layout of your PowerVault FluidFS NAS. Use this worksheet while performing the network
configuration steps in the NAS IDU.
Switch Requirements Checklist
Client/Primary Network SAN Network
Jumbo Frames Enabled (9216
MTU)
 Recommended  Required
Port Fast Enabled  Required  Required
Flow Control Enabled  Recommended  Required
IPv6 Enabled  Required (during initial deployment)  Required
Number of NAS Appliances Number of MD-series Arrays Type of Network
○ 1 ○ 2 ○ 1 ○ 2 ○ Routed ○ Flat
NAS Appliance 0 Service Tag:
NAS Appliance 1 Service Tag:
NAS Cluster Name:
Primary Client Network
NAS Management VIP:
Client Access VIP:
Gateway:
Subnet Mask:
NAS Appliance 0
Controller 0 IP: Controller 1 IP:
NAS Appliance 1
Controller 2 IP: Controller 3 IP:
MD Array 0
Controller 0, Management IP: Controller 1, Management IP:
MD Array 1
Controller 0, Management IP: Controller1, Management IP:
Interconnect (Private) Network
Select a private Class C subnet
○ 10.255.254.x ○ 172.31.254.x ○ 192.168.254.x ○___.___.___.x
6
30 PowerVault FluidFS NAS Setup Worksheet