Users Guide

Table 21. Library error codes (continued)
Code (H) Description
Panel
Indication
Action Required
00B8
accessor error #1.
Reverse REV position (PP1) error
(accessor origin not detected or
FWD position detected). Suspect
the P origin sensor, FWD sensor,
or P motor.
CHK 00B8
1. Check the accessor locking screw and
remove it if it is installed. See “Removing
the accessor locking screw” on page 28.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library
Verify before normal library operations
resume.
• If the problem persists, see “Contacting
Dell technical support” on page 111.
00B9
accessor error #2.
Forward FWD position (PP2)
error (accessor origin detected
or FWD not detected). Suspect
the P origin sensor, FWD sensor,
or P motor.
CHK 00B9
00BA
accessor error #3.
PUT/GET/bar code reader
position (PP4/PP5/PPBF/PPBR)
error (accessor origin or FWD
detected, or cell full). Suspect
the P origin sensor, FWD sensor,
or P motor.
CHK 00BA
00BC
During initialization, the
accessor origin could not be
detected. Suspect the P origin
sensor, FWD sensor, or P motor.
CHK 00BC
00BD
During accessor movement, the
movement stop condition
detected. Suspect the P encoder
sensor or P motor.
CHK 00BD
00BF
No gap condition detected at the
completion of accessor
operation. Suspect the centering
sensor, P origin sensor, FWD
sensor, or P motor.
CHK 00BF
00C0
accessor operation disabled
because a cartridge magazine
was removed. Suspect the
magazine set sensor.
CHK 00C0
1. Conrm that the magazine is closed.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library
Verify before normal library operations
resume.
• If the problem persists, see “Contacting
Dell technical support” on page 111.
124 Dell PowerVault TL1000 Tape Autoloader: User's Guide