Users Guide

Table 21. Library error codes (continued)
Code (H) Description
Panel
Indication
Action Required
00DD
An error detected during bar
code reader rmware check.
Suspect the bar code reader
cable connection.
CHK 00DD
1. Initiate an inventory. See “Conducting a
library inventory” on page 57 (Operator
Panel) or “Conducting a library inventory”
on page 70 (Web User Interface).
2. Cycle the power supply and try again.
• If the problem is corrected, run Library
Verify before normal library operations
resume.
• If the problem persists, see “Contacting
Dell technical support” on page 111.
00E0
Write operation not nished
within 1 ms when writing data to
flash memory.
CHK 00E0
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before normal library operations resume.
• If the problem persists, see “Contacting Dell
technical support” on page 111.
00E1
Clear operation not nished
within 10 seconds when clearing
a sector in flash memory.
CHK 00E1
00E2
Error detected in tape library
conguration stored in flash
memory.
CHK 00E2
00E3
Checksum error detected in
flash memory.
CHK 00E3
00F0
Sensor error #1.
Accessor encoder sensor B error
detected during blink check.
Suspect the accessor encoder
sensor B.
CHK 00F0
126 Dell PowerVault TL1000 Tape Autoloader: User's Guide