Users Guide

If the symbol is... It means...
This part or unit is heavy but has a weight smaller than 18 kg (39.7
lb). Use care when lifting, removing, or installing this part or unit.
(C008)
A hazardous condition due to the unit's susceptibility to electrostatic
discharge.
Laser safety and compliance
Table 1. Class I Laser Product
The library might contain a laser assembly that complies with the performance standards
set by the US Food and Drug Administration for a Class I laser product. Class I laser
products do not emit hazardous laser radiation. The library has the necessary protective
housing and scanning safeguards to ensure that laser radiation is inaccessible during
operation or is within Class I limits. External safety agencies have reviewed the library and
have obtained approvals to the latest standards as they apply.
Performing the safety inspection procedure
Before you service the unit, complete the following safety inspection procedure.
1. Stop all activity between the host and the library’s tape drive.
2. Turn off the power to the library by switching the Power button on the rear of the tape library to the Off
position.
3. Disconnect the tape drive’s SAS cable.
4. Unplug the library’s power cord from the electrical outlet and the library’s power supply unit.
5. Check the library’s power cords for damage, such as a pinched, cut, or frayed cord.
6. Check the tape drive’s SAS cable for damage.
7. Check the cover of the library for sharp edges, damage, or alterations that expose its internal parts.
8. Check the cover of the library for proper t. It should be in place and secure.
9. Check the product label at the rear of the library to make sure that it matches the voltage at your
outlet.
Rack safety
The following general safety information must be used for all rack-mounted devices.
DANGER
Safety and environmental notices
xv